Bollard Lights

I have a 110 'sidewalk. I made 11 loops of 14-2WG exposed to 10 'intervals above the existing ground. This voltage is fed to an end. I intend to make my own light path from a terminal Latitudes Composite 4 "x 4 post sleeves" and a glass decor from the CAP post. The inside of the sleeves incorporate an incandescent bulb 75 watts. The sleeves will be cut to post a vent Soft Panel on one side, which emits light. My question, is there a motion detector mini Done that could be installed in each control terminal of each light As you grow up / down foot. A standard motion detector would consider offensive. The situation would be easier if I had shot 14-3WG. Thus, a sensor can be installed on both ends of the promenade. I not really want to incorporate the ground like a double neutral. I think each individual light switch as you go would be great. I'm open to suggestions. Thank you

I have a motion sensor that I just bought is quite low. Is $ 14 each.

it is a plug in one, and I think you need you can wire in. The more you need to be used outdoors. Perhaps something like the second.

But looking around, there are hundreds of different models.

.